Beam ExpanderThorlabs

Highly reflective (HR) coatings are used to minimize loss while reflecting lasers and other light sources. Absorption and scatter during reflection lead to decreased throughput and potential laser-induced damage. HR coatings are used in common laser optics applications such as folding a laser’s beam path and laser cavity end mirrors.

Metallic mirror coatings are used to create reflective components for many applications but laser applications tend to require a higher reflectivity than those offered from standard metallic mirror coatings. Because of this, multilayer dielectric HR coatings are usually used for laser mirrors instead of metallic mirror coatings, as they can achieve higher reflectivity. Metallic surfaces reflect light because loosely attached electrons freely oscillate with incident light waves without much impedance or hindrance, but all metals will absorb some amount of incident light. This makes metallic mirror coatings susceptible to damage when used with high power lasers.1

Reflectivebeam expander

SINGAPORE OptoSigma SEA 83 Science Park Drive, #02-01.The Curie, 118258 TEL. +65 6909 9318 sales@optosigma-sea.com SINGAPORE

Variable beam expanderdesign

Dielectric overcoats also improve handling of metallic mirrors, increase the durability of the metal coating, provide protection from oxidation, and enhance the reflectance of the metal coating in specific spectral regions. Metal coatings are very delicate without a protective coating and require extra care during handling and cleaning. The surface of an unprotected metal coating should never be touched or cleaned with anything other than clean, dry air. Isopropyl alcohol or acetone can be used to clean metal mirrors with a dielectric coating. Table 1 shows a list of Edmund Optics’ standard metallic mirror coating options, while Table 2 shows a list of Edmund Optics’ standard dielectric HR laser coatings.

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

UK Elliot Scientific Limited Unit 11 Sandridge Park, Porters Wood, St Albans, AL3 6PH TEL. +44 (0)1582 766 300 sales@elliotscientific.com United Kingdom

Variable beam expanderprice

USA OptoSigma Corporation 1540 Scenic Avenue, Suite 150, Costa Mesa, CA. 92626 TEL. +1-949-851-5881 sales@optosigma.com USA

Dielectric HR coatings reflect light based on constructive interference during Fresnel reflections and have the complete opposite purpose of AR coatings in that they utilize constructive interference to maximize Fresnel reflections instead of utilizing destructive interference to minimize them (Figure 1). The constructive interference is caused by alternating layers of high and low refractive index materials with thicknesses specifically chosen to maximize reflectivity at a given wavelength range. In a λ/4 dielectric mirror, also known as a Bragg mirror, the thickness of each layer corresponds to a quarter of the design wavelength. Layer thickness is based on the wavelength in the material, not the vacuum wavelength.2