LED lightDiffuser Channel

※In order to ensure waterproof and anti-corrosion, after the power cord is screwed into the terminal, it is recommended to inject the terminal with one-component silica gel (or use neutral glass glue or waterproof grease) to cover the exposed copper wire of the power cable for protection.

LED LightDiffuser Cover

What are the advantages of diffuse light strips? 1. It has a wide range of applications, suitable for profiles with a thickness of 3.5cm or more, with uniform light emission without shadows 2. 170 degree wide-angle lighting makes the light of the finished light box more uniform, while the lighting angle of traditional roller blinds is about 120 degrees 3. The advantages are more obvious on the 3.5~10cm ultra-thin light box, the light is well-proportioned, and the materials are more saved, and the installation labor cost is greatly reduced 4. Two-line mode, can be freely cut according to the needs, stocking is easier, and the adaptation is more extensive Installation:

How todiffuse LEDstrip DIY

The diffuse reflection light bar is a new type of backlight product made by Awelled on the basis of the conventional LED patch roller shutter lamp with higher brightness and larger illuminating angle; Awelled LED diffuse reflection light strips are generally made of high thermal conductivity aviation aluminum The substrate is made of high-power 3528beads as the light source, and special PMMA optical lens is added; its main advantage is ultra-high brightness and 170 degree wide-angle light, with fewer lamp beads/light bars per unit area Obtain the best luminous flux and light source distribution optimization. Is it a diffuse light strip?

LED lightdiffuser material

LEDStrip Diffuser Flexible

1 , DC12/24V /100-240Vac input 2,  High CRI Osram High power chip 3, Only light heads at side can be adjustable 4,  Length 500 mm

How to install diffuse light bar ? ※The main line uses a cable wire above 2×1.5 mm2. If the lens light bar power cord needs to be lengthened, you must use a wire with a specification above 0.5mm2/18#, so as to avoid overloading the power cord and cause excessive heating of the power cord, resulting in undesirable consequences. The length of the power cord between led power supply and lens light bar should not exceed 3 meters, otherwise the line loss will increase and the total power will increase as well.

*Surface mount led linear light bar                                                                                                  *Different size led profile can be choice . *Easily and fastly install or replace traditional lamp *LEDs qty can be 72 /90/120/144/168pcs/M

Cheap Ways todiffuse LED light

*Surface mount led linear light bar                                                                                                                          *Different size led profile can be choice . *Easily and fastly install or replace traditional lamp *LEDs qty can be 72 /90/120/144/168pcs/M

*360° round luminous surface, uniform light emission, suitable for spatial decorative lighting. *High luminous efficiency, *Support pendant and surface mounted installation.

Scope of application：4-18cm light boxes, indoor and outdoor display light sources, ceiling, glass building decorative lighting Singles LED cuttable，applicable for all different sizes of light box

※Do not touch or work on this product with power, it is recommended to use a switching power supply (with short-circuit protection, over voltage protection and over current protection) that has passed relevant safety certifications.

※When the wire conductor at the tail end of the light bar is exposed, first use diagonal pliers to strip the wire about 10mm, and screw it into the terminal for insulation protection.