These are optional connectors for the power supply to support additional power needed by any PCI Express* Add-in Card (AIC). The most common PCIe* Add-in Card that uses these connectors are discrete graphics cards. The PCIe* CEM Specification defines different connectors based on the power used by the Add-in Card which can range from 75 watts up to 600 watts.

DS Electric generation service that is provided at retail pursuant to the Applicable Legal Authorities under the Company’s retail electric tariffs and under any other agreements or arrangements between the Company and Customers, to any Customer that is not being served by an EGS. Default Allocation Assessment – shall have the meaning ascribed to it under the PJM Agreements. Delivery Period – The delivery period specified in an Appendix C Transaction Confirmation. Delivery Point – Means the applicable zone of the Company as designated by PJM. DS Customer(s) – Retail customers who are provided Default Service pursuant to the terms of this Agreement, the Applicable Legal Authorities and the Company’s retail tariffs.

There are no specific requirements for output wire harness lengths, as these are largely a function of the intended end-use chassis, motherboard, and peripherals. Ideally, wires should be short to minimize electrical/airflow impedance and simplify manufacturing, yet they should be long enough to make all necessary connections without any wire tension (which can cause disconnections during shipping and handling). The recommended minimum harness length for general-use power supplies is 150 mm for all wire harnesses. That is very short, and most power supplies need wire harness cables longer than 150mm, consider market conditions and chassis sizes for power supply market wire harness lengths. Measurements are made from the exit port of the power supply case to the wire side of the first connector on the harness.

haemophilia means an inheritable disease, usually affecting only male but transmitted by women to their male children, characterised by loss or impairment of the normal clotting ability of blood so that a minor would may result in fatal bleeding;

Basic functions for smooth management · Remote monitoring. Device information that can be acquired includes basic information such as phone number and device ...

Clinical relevance and scope of accidental extracoronary findings in coronary computed tomography angiography: a cardiac versus thoracic FOV study.

Kit means a set of components that are packaged together and intended to be used to perform a specific in vitro diagnostic examination, or a part thereof;

UMDAP means the Uniform Method of Determining Ability to Pay and refers to the 2 method used for determining the annual Client liability for Mental Health Services received from the 3 COUNTY mental health system and is set by the State of California.

Table 5-2: Main Power Connector Pin-Out shows pin outs and profiles for typical power supply DC harness connectors. The power supply requires an additional two-pin, power connector.

Technical Data Sheet. RGB LED Strip 12V 6mm. RGB LED STRIP 12V, 6mm. Working conditions. Temperature: -20 +70 C°. Humidity: 30 - 70 %. Temperature range. R: 620 ...

The video detection system shall reliably detect vehicle presence when the image sensor is mounted 30 feet (10 m) or higher above the roadway, when the image sensor is adjacent to the desired coverage area, and when the length of the detection area or field of view (FOV) is not greater than ten (10) times the mounting height of the image sensor.

12VHPWR pinout

The video detection system shall reliably detect vehicle presence when the image sensor is mounted 10m (30 ft.) or higher above the roadway, when the image sensor is adjacent to the desired coverage area, and when the length of the detection area or field of view (FOV) is not greater than ten (10) times the mounting height of the image sensor.

Unless otherwise noted, information in this section is taken from Annex A: Marine Personnel Carrier (MPC) Family of Vehicles (FOV) Requirements Set to the Marine Personnel Carrier Request for Information (RFI), February 17, 2011.

Pin 10 is used for both main 12V Power and the optional Voltage Sensing wire for the power supply to provide the correct voltage to the motherboard. Voltage Sensing Pin details in Section 4.2.3.

PCCD013: Obiettivo catadiottrico ad ampia visione laterale, per sensori da 1/3".

3645 Followers, 1522 Following, 1040 Posts - DCS Lighting (@dcslighting) on Instagram: "American made off-road and marine lighting • No holes drilled rock ...

SATAPower

Xxxxxxx Group means (i) any member of the Xxxxxxx Family, (ii) Xxxxxxx Energy Partners I, LP and SEP Management I, LLC, (iii) Xxxxxxx Parent, (iv) Xxxxxxx Investor, (v) Xxxxxxx Production Partners LP, (vi) Xxxxxxx Oil & Gas Corporation, (vii) Blackstone Newco and (viii) any Person Controlled by any one or more of the foregoing (other than the General Partner, the Partnership or any of their respective Subsidiaries).

For a sense pin that needs to be grounded, it must be connected to ground either directly in the power supply or via a jumper to an adjacent ground pin in the connector.

This connector has the same mechanical and electrical characteristics as the PCIe* 2x3 Auxiliary Power Connector, detailed in Section 5.2.2.4.1.

For Gaia DR2, the solar system pipeline worked on a pre- determined list of transits in the field of view (FOV) of Gaia.

Vector means a carrier that is capable of transmitting a pathogen from one organism to another including, but not limited to, flies and other insects, rodents, birds, and vermin.

Power supply

The cable plug connector housing for the 12V-2x6 connector has all dimensions shown in mm. Slight changes to this connector that do not affect connector mating are permitted. Reference latest PCI-SIG documentation for latest information about this connector.

If board power requirements are higher than what can be provided by the 10 pin Main Board Connector, the Extra Board Power connector can be used. This connector can provide an additional 216-288 watts of power to the motherboard to support multiple PCIe* connectors, multiple USB ports, or other expansion slots.

The 12V-2x6 PCB connector is labeled with a “H++” to differentiate it from the previously defined 12VHPWR connector, which was labelled with the “H+” symbol.

Crimp Contacts inside of the cable plug are can either use the 4-Spring design, 3-dimple design (as shown in Figure 5-11), or equivalent design. Any design is required to meet the design and reliability requirements that are needed to provide the high current per pin of the 12V-2x6 connector. Whether using the 4-Spring, 3-Dimple Design, or equivalent; the design criteria recommended for these mechanical connections are listed below:

Recommended for PSU designed for High End Desktop and Gaming systems that might need 12V power for Fans, LEDs, or Liquid Cooling pumps. Only populate pins 1 and 2.

Bioassay means the determination of kinds, quantities or concentrations and, in some cases, the locations of radioactive material in the human body, whether by direct measurement, in vivo counting, or by analysis and evaluation of materials excreted or removed from the human body. For purposes of these rules, “radiobioassay” is an equivalent term.

ATXpower supplypinout

Epinephrine auto-injector means a device for immediate self-administration or administration by another trained person of a measured dose of epinephrine to a person at risk of anaphylaxis.

Pump spray means a packaging system in which the product ingredients within the container are not under pressure and in which the product is expelled only while a pumping action is applied to a button, trigger or other actuator.

In estimating the fair value of the reporting unit utilizing a discounted cash flow (“DCF”) valuation technique, the Company incorporates its judgment and estimates of future cash flows, future revenue and gross profit growth rates, terminal value amount, capital expenditures and applicable weighted-average cost of capital used to discount these estimated cash flows.

Since the Extra Board Connector is optional on the motherboard and is expected to be needed only for higher power motherboards, this can be correlated to PSU size. Therefore, this connector is only required on PSU that are greater than 450 Watts. It is optional on PSU that is equal to or less than 450 Watts.

The 2x4 Auxiliary Power Connector consists of a PCB Header, mounted on a PCIe* Add-in Card, and a mating 2x4 Cable Plug harness. The 2x4 PCB header is designed to accept both the mating 2x4 Cable Plug as well as the 2x3 cable plug, for backward-compatibility. The Add-in Card PCB Header is keyed to ensure that a 2x3 cable plug from a PSU will be properly aligned when it is mated with a 2x4 PCB Header. Two Sense pins in the 2x4 PCB header allow the PCIe* Add-in Cards to detect the power available from the cable. The 2x4 Cable Plug asserts (grounds) two sense pins to indicate that 150 watts are available to the PCIe* Add-in Card through this cable, while the 2x3 plug asserts only one sense pin, to signal that only 75 watts may be drawn from the cable. The 2x4 Cable Plug has the following requirements:

BMS means the Company, all related companies, affiliates, subsidiaries, parents, successors, assigns and all organizations acquired by the foregoing.

Tsiklakis et al (2005) have observed a 20% decrease in effective dose by protecting the thyroid gland during CBCT, although this was with a large FOV scanner.

ATXpower supplySpecification

Einplatinen-Kameras, ideal für kostensensitive USB 2.0- und OEM-Anwendungen. Die USB 2.0-Platinenkameras von The Imaging Source verfügen über CMOS-Sensoren von ...

genocide means any of the following acts committed with intent to destroy, in whole or in part, a national, ethnical, racial or religious group, as such:

This power connector is designed as the main board connector and for smaller to medium size boards this is the only connector that is needed. This connector can provide up to 216 to 288 watts of power using the assumption that each pin can provide 6–8 Amps. Board designers need to figure out total board power and if this single connector provides enough power for each board.

Power supplyunit

If a power supply uses a modular cable connection, an additional 12V-2x6 PCB Header connector will be required in the housing of the power supply to accept “double-ended” 12V-2x6 cables. Details below are provided via the PCIe* CEM Revision 5.1 Specification.

Based on the dosimetry evidence and the range of potential clinical applications of CBCT, the Panel judged that equipment with large, fixed FOV was inappropriate for general dental use, where diagnostic tasks are often localised to one, or a few teeth.

The 12V-2x6 cable plug housing has been defined with two options that provide different physical shroud designs for the sideband signals, as shown in Figure 5-4. The thumb-ridge feature is present on one design (Option 1) and absent on the other (Option 2).

The 12V-2x6 Auxiliary Power connector is designed to deliver up to 600 watts of 12V power directly to a PCIe* Add-in Card. This power connector is not compatible with the 2x3 or 2x4 auxiliary power connectors. The 12V-2x6 connector power pins have a 3.0 mm spacing while the contacts in a 2x3 and 2x4 connector lie on a larger 4.2 mm pitch. The 12V-2x6 auxiliary power connector includes twelve large contacts to carry power and four smaller contacts beneath, to carry the sideband signals.

201838 — Business Insider ranked all of the network's 43 notable original shows based on how well they were received by critics (using data from the reviews aggregator ...

Urth Circular Polarizing Filters (CPL Polarizing Filters) cut reflected light from any direction. By cutting polarized light, our CPL Filters increase contrast ...

Main Power Connector for motherboard with control and standby rail connections are required. Smaller board sizes can only use this connector.

G · Arm, Keeps objective above platform. Hold the arm and base when carrying ; H · Base, Keeps microscope stable ; I, Mirror, Redirects light to the slide. Can be ...

UL Listed or recognized component appliance wiring material rated min 85 °C, 300 VDC shall be used for all output wiring.

The mating pilers are unique to this design, refer to figure below. Note connector color can be changed work with connector companies to see what they provide. Motherboard connector color is recommended to be white to show that power into the board is different color than power going out of the board (3 mm SATA Power Connector), which is recommended to be black.

This connector may be provided by other connector companies beyond what is listed above. Contact the preferred connector provider for details. Below is the key for this connector, from motherboard connector view. 18 AWG is recommended for all wires. Connector needs to support 8 amps per pin.

Find the contact lenses that fit your lifestyle. Choosing the right contacts for your eyes is essential for clear vision and comfort.

Shop our wide variety of LED strip lights to enhance your home, commercial space, or more! The compact size, low power consumption, and reliability make ...

Dyslexia means a disorder of constitutional origin manifested by a difficulty in learning to read, write, or spell, despite conventional instruction, adequate intelligence, and sociocultural opportunity.

The 12VHPWR connector, introduced in the earlier 2.0 revision of this document and the PCIe* CEM 5.0 Specification, has been deprecated and replaced with the 12V-2x6 connector, as shown in th PCIe* CEM 5.1 specification. While the 12V-2x6 connector specification is mechanically identical to the 12VHPWR connector in most respects, multiple updates have been incorporated into the newer, 12V-2x6 connector, to improve its reliability.