USBNight VisionCamera

Surfaces to be bonded should be clean and dry. Dispense a drop or drops to one surface only. Apply only enough to leave a thin film layer after compression. Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less that one minute and maximum strength is attained in 24 hours. Wipe off excess adhesive from the top of the container and recap.

Usb infrared camerafor night vision

We've got a data capture, some extracted CSV data and a Beagle USB analyzer data dump here (The viewer for Beagle USB files is free and for all OS's)

Bestusb infrared camera

This UTi165K version has real-time data transmission to a computer for analysis over USB. It also features three viewing modes: Thermal (infrared image), Digital (regular camera), and Fusion (a blend of the two). We also carry the UTi165H, which has only a thermal viewing mode and no USB output.

USBthermalcamera- Raspberry Pi

This video camera takes photos of temperatures! This camera is specifically tuned to work in the 30˚C~45˚C / 86˚F~113˚ F range with 0.5˚C / 1˚ F accuracy, so it's excellent for human temperature & fever detection. In fact, this thermal camera is often used by companies/airports/hotels/malls to do a first-pass fever check: If any person has a temperature of over 99˚F an alarm goes off so you can do a secondary check with an accurate handheld temperature meter.You may have seen thermal 'FLIR' cameras used to find air leaks in homes, but those cameras have a very wide temperature range, so they're not as accurate in the narrow range used for fever-scanning. This camera is designed specifically for that purpose!

If you buy less than a full reel, you'll get a single strip, but it will be a cut piece from a reel which may or may not have a connector on it. If the piece comes from the end of the reel, the connector may be on the output end of the strip!

Thermalcamera USBPC

CA500RT is a black, medium-viscosity, rubber-toughened, ethyl cyanoacrylate adhesive. It provides superior shock and thermal resistance when bonding rubbers, metals, and plastics in harsh environments and displays excellent strength and flexibility on a variety of substrates.

Adafruit NeoPixel Digital RGB LED strips come to us in 4 or 5 meter reels with a 2 or 3-pin JST SM connector on each end and separated power/ground wires as shown in the picture below. If you order a full 4 or 5 meters, you get the full reel with both connectors installed.

There's a color 2.8" 320x240 TFT screen which gives real-time temperature readings from an interpolated 160x120 thermal resolution, with hot-spot temperatures labeled. You can also set temperature ranges for alerts, F or C units, color palettes, etc. There's a built-in li-poly battery so it's fully portable. You can recharge it over USB.