The polarization state of light often matters when light hits an optical surface under some angle. A linear polarization state is then denoted as p polarization when the polarization direction lies in the plane spanned by the incoming beam and the reflected beam. The polarization with a direction perpendicular to that is called s polarization. These indications have a German origin: s = senkrecht = perpendicular, p = parallel.

A radially polarized laser beam may be generated from a linearly polarized beam with some optical element, but it is also possible to obtain radially polarized emission directly from a laser. The advantage of this approach, applied in a solid-state bulk laser, is that depolarization loss may be avoided [4]. Furthermore, there are applications benefiting from radially polarized light.

Note that a very small gain or loss difference for the two polarization directions can be sufficient for obtaining a stable linear polarization, provided that there is no significant coupling of polarization modes within the laser resonator.

The polarization state of monochromatic light is often described with a Jones vector, having complex electric field amplitudes for <$x$> and <$y$> direction, if propagation occurs in <$z$> direction. That Jones vector may be constant over some area across the beam, or it may vary, for example for a radially polarized beam (see above). The effect of optical elements such as waveplates, polarizers and Faraday rotators can be described with Jones matrices, with which the Jones vectors can be transformed by multiplication. (One assumes a linear relationship between input and output amplitudes.) A whole sequence of such optical elements can be described with a single Jones matrix, which is obtained as the product of the matrices corresponding to the components.

Circularlypolarized light

There are also partially polarized states of light. These can be described with Stokes vectors (but not with Jones vectors). Further, one can define a degree of polarization which can be calculated from the Stokes vector and can vary between 0 (unpolarized) and 1 (fully polarized).

Polarization oflight

It is our mission to be the go to leaders in the aviation industry. GlobalAir.com is your partner in connecting you with relevant information and resources.

In many respects, light can be described as a wave phenomenon (→ wave optics). More specifically, light waves are recognized as electromagnetic transverse waves, i.e., with transverse oscillations of the electric and magnetic field.

Unpolarizedlight

In the simplest case, a light beam is linearly polarized, which means that the electric field oscillates in a certain linear direction perpendicular to the beam axis, and the magnetic field oscillates in a direction which is perpendicular both to the propagation axis and the electric field direction. The direction of polarization is taken to be the direction of the electric field oscillations (i.e., not the magnetic ones). For example, a laser beam propagating in <$z$> direction may have the electric field oscillations in the vertical (<$y$>) direction and the magnetic field oscillations in the horizontal (<$x$>) direction (see Figure 1); it can be called vertically polarized or <$y$>-polarized. In a different perspective, this is also shown in the second part of Figure 2.

I would have been glad to finally remove a serious mistake, but I believe my equations are correct. They agree with those in various textbooks and e.g. also in Wikipedia. Your argument concerning energy swapping back and forth between electric and magnetic fields looks somewhat plausible but is not accurate.

Elliptical polarization

Using our advertising package, you can display your logo, further below your product description, and these will been seen by many photonics professionals.

Here you can submit questions and comments. As far as they get accepted by the author, they will appear above this paragraph together with the author’s answer. The author will decide on acceptance based on certain criteria. Essentially, the issue must be of sufficiently broad interest.

Of course, the polarization can have any other direction perpendicular to the beam axis. Note that a rotation of the polarization by 180° does not lead to a physically distinct state.

Electric polarization

In the previous cases, the direction of the electric field vector was assumed to be constant over the full beam profile. However, there are light beams where that is not the case. For example, there are beams with radial polarization, where the polarization at any point on the beam profile is oriented in the radial direction, i.e., away from the beam axis.

Note that radial or azimuthal polarization state requires a zero electric field strength and thus also a vanishing optical intensity on the beam axis; it is not compatible with a Gaussian beam, for example. Radially polarized beams frequently exhibit a kind of donut profile.

The degree of linear polarization is often quantified with the polarization extinction ratio (PER), defined as the ratio of optical powers in the two polarization directions. It is often specified in decibels, and measured by recording the orientation-dependent power transmission of a polarizer. Of course, the extinction ratio of the polarizer itself must be higher than that of the laser beam.

Linearpolarization

On the other hand, the polarization state of the laser output can be disturbed e.g. by random (and temperature-dependent) birefringence, such as occurs e.g. in optical fibers (if they are not polarization-maintaining or single-polarization fibers) and also in laser crystals or glasses as a result of thermal effects (→ depolarization loss). If the laser gain is not polarization-dependent, small drifts of the birefringence may lead to large changes of the polarization state, and also a significant variation in the polarization state across the beam profile.

While optical activity usually results from the presence of chiral molecules, with a concentration difference between the two possible enantiometers, it can also be induced by a magnetic field in a substance which is not naturally optically active. That is called the Faraday effect, and is exploited in Faraday rotators and Faraday isolators.

Linearly polarized light can be depolarized (made unpolarized) with a polarization scrambler, which applies the mentioned random polarization changes, or at least quasi-random changes.

There are cases where polychromatic light can be described with a single Jones vector, since all its frequency components have essentially the same polarization state. However, the polarization state is substantially frequency-dependent in other cases.

A circular polarization state can mathematically be obtained as a superposition of electric field oscillations in the vertical and horizontal direction, both with equal strength but a relative phase change of 90°. Effectively, this leads to a rapid rotation of the electric field vector – once per optical cycle – which maintains a constant magnitude.

If the oscillations of the horizontal and vertical electric field vector do not have the same strengths, one has the case of an elliptical polarization, where the electric field vector, projected to a plane perpendicular to the propagation direction, moves along an ellipse.

Linearpolarization example

As explained above, a waveplate or other birefringent optical element may rotate the direction of linear polarization, but more generally one will obtain an elliptical polarization state after such an element. True polarization rotation, where a linear polarization state is always maintained (just with variable direction), can occur in the form of optical activity. Some optically active substances such as ordinary sugar (saccharose) can produce substantial rotation angles already within e.g. a few millimeters of propagation length. Optical activity can be accurately measured with polarimeters.

Fully polarized states can be associated with points on the so-called Poincaré sphere. Partially polarized states correspond to points inside that sphere; unpolarized light is represented by the point at its center.

There are also azimuthally polarized beams, where the electric field direction at any point is tangential, i.e., perpendicular to a line through the point and the beam axis.

Polarization

By submitting the information, you give your consent to the potential publication of your inputs on our website according to our rules. (If you later retract your consent, we will delete those inputs.) As your inputs are first reviewed by the author, they may be published with some delay.

Note: this box searches only for keywords in the titles of articles, and for acronyms. For full-text searches on the whole website, use our search page.

Your first plot shows the magnetic and electric field in phase – which is wrong. The magnetic field is made from the changing electric field. The two fields swap energy back and forth. Hence the magnetic field is at a maximum when the electric field has the largest rate of change, that is, at zero E field. The magnetic field zeros in strength when the electric field rate of change is zero, at it's peak. These are a simple consequence of Maxwell's Equations and is covered in most any text on E&M. The worst error I have found in years of use of your marvelous resource!

Note: the article keyword search field and some other of the site's functionality would require Javascript, which however is turned off in your browser.

A light beam is called unpolarized when the analysis with a polarizer results in 50% of the power to be in each polarization state, regardless of the rotational orientation. Microscopically, this usually means that the polarization state is randomly fluctuating, so that on average no polarization is detected. Note that such fluctuations are not possible for strictly monochromatic light.

Jones vectors can be used only for fully defined polarization states, not for unpolarized or partially polarized beams (see below) having a stochastic nature.

One distinguishes left and right circular polarization (see Figure 2). For example, left circular polarization means that the electric (and magnetic) field vector rotates in the left direction, seen in the direction of propagation. For an observer looking against the beam, the rotation of course has the opposite direction.

Please do not enter personal data here. (See also our privacy declaration.) If you wish to receive personal feedback or consultancy from the author, please contact him, e.g. via e-mail.