Metrology softwarefree

Metrology softwarefree download

A leading manufacturer has seen their production time halved from 4 hours to 2 hours, by adopting innovative manufacturing technology developed by MSP.

Bestmetrology software

Like I said in my other post, I was curious to clamp this lense (Canon J15x9.5B ) on a bench in front of my Eclair ACL. I don't know if it will properly cover the frame and I don't know how sharp it can be.

If I have a B4 mount lense but no camera mount or adaptor, where on the lense flange do I measure the flange focal distance from?

Metrology softwareproducts

SST is now manufacturing up to 7 times more parts per week due to MSP reducing their part setup time from 4 hours to 25 minutes with their advanced manufacturing products.

After MSP automated its setup and alignment procedures, 3T-am now has the potential to use its machines at full capacity - an increase of 157% compared to its usage before.

Just to be really clear. The flange on the lense has three wings or tangs that stick out, then it's steped down to a smaller diameter behind this. I thought that flange focal distance would probably be measured from the rear of the flange with wings on it, but wanted to make sure that it wasn't from the rear of the steped down flange.

MSP specialises in the use of automation to eliminate errors from part manufacturing processes. We deliver maximum part accuracy, less scrap and full traceability using our world-class precision software and hardware solutions.