We’ve detected that JavaScript is disabled in this browser. Please enable JavaScript or switch to a supported browser to continue using x.com. You can see a list of supported browsers in our Help Center.

Choose how to display evenly-spaced marks to assist with lighting device placement; all options except None also provide master snap points along the lighting pipe when hovering over it.

International Light TechnologiesInc

Select the Make default for new documents option to always use the specified class as the default class for lighting pipe objects in new files.

Enter a name for identification and reporting purposes. When the lighting pipe is used as a hanging position, this name automatically populates the Position field of any attached load objects.Â

Select Existing class to use an existing class from the document as a prefix. Select Other prefix to create a new custom prefix without creating the class.

For Polyline Insertion mode, selects the method for drawing the polyline upon which the object is based; see Creating polylines.

ILT2400

Select the 3D profile of the pipe; this setting affects rendering speed (shapes other than round may render more quickly)

Insert and configure a lighting pipe object with the Lighting Pipe tool. Lighting pipe objects function as rigging objects, so lighting devices and other loads can attach directly to the lighting pipe. Lighting pipes support full 3D rotation, and they can be used to create schematic views.

Alternatively, create a polyline and then select the Create Objects from Shapes command (see Creating objects from shapes).

To control appearance and visibility, select a class from the list of classes present in the drawing, or create a new class. Select to place the part attributes in the same class as the lighting pipe object.

Aligns the center tick mark with the snap grid (see Snapping to the grid); this does not change the tick mark spacing but it may change the Offset value

In addition to individual objects created using the Lighting Pipe tool, it you can access a variety of standard lighting pipe resources and custom styles (see Concept: Plug-in object styles).

Specifies the total length of the lighting pipe; for a single-segment lighting pipe, the length can be edited by changing this value. (Change the segment length or edit multi-segment pipes with the Reshape tool.)

Click Line Insertion mode and either click Vertex submode to place the pipe from start to end points, or Center submode to place it from the center to an end.

Spaces the tick marks based on the total length of the pipe, or based on each segment of a pipe that is considered divided into two equal sections