What is Class7 radioactivematerial

Tighten the top screw lightly with a screw driver. Do not overtighten the screw, you will come back to tighten them in a few steps.

Radioactive material is any material containing radionuclides where both the activity concentration and the total activity in the consignment exceed specified values.

Class7 radioactiveexamples

Congratulations, you have successfully installed the Molle Adapter. Please double check your screws frequently to make sure they remain tight and your gear is secured.

The following instructions are intended to help you install our Revision 3 Molle Adapter to your Blackhawk Taser 7 holster on your own. If you need further guidance, please email us and we will help you as quickly as possible.

We are not responsible for incorrect installation. We are ALWAYS available for installation guidance, please do not hesitate to reach out to us with questions.

Radioactive 7Meaning

Set the 4Bros Molle Adapter on the holster with the threaded posts aligned with the chamfered holes on the adapter as shown

Radioactive 7placard

All three screw heads should be recessed from the surface of the adapter slightly. Please double check to make sure the correct screws have been used and they are tight.

Class7 radioactivematerial transport

Repeat the installation of the screws to the second adapter as shown. After the fit of each Molle attachment has been verified, remove each screw one at a time and add removeable Loctite threadlocker to each screw.

Radioactive materials can also be defined as materials capable of the spontaneous release of ionizing energy capable of causing harm by removal of electrons from an atom (ionizing radiation).  Examples include cobalt, uranium hexafluoride, and uranium oxide (i.e., yellow cake uranium).

Tighten the 10-32 Flat Head Screws lightly until all three are inserted, then check fit. We recommend adding threadlocker to the screws one at a time after verifying fit at this stage. Removeable Loctite 242 threadlocker or Vibra-tite 121 are our preferred brands. Make sure the screws are good and tight before proceeding to the next step.

You will need a Phillips Screw Driver, 1/8 Allen wrench, Blackhawk Taser 7 Holster and our Molle Adapter to complete the installation.

Open the Blackhawk Belt Attachment and verify the screws match the above picture. Blackhawk has updated their holster to use 10-32 screws, where as the older models used 8-32 screws. (No worries, our adapter works with both)

Align the top hole of the molle attachment with the top hole of the 4Bros Molle Adapter plate and start the 5/16 long 8-32 screw in the threaded post.