LOCA UV Glue

HumiSeal Vivid Cure™ UV6041 should be stored between 8°C – 28°C in tightly closed, light-blocking containers, away from direct sunlight. Keep from freezing. Allow material to equilibrate to process area temperature for 24 hours before use. Please refer to product labeling for shelf-life information. While the material can be heated to facilitate degassing prior to use, this operation should be conducted only on the amount of adhesive to be immediately used.  Multiple heating cycles of the bulk container or elevated temperature storage of HumiSeal Vivid Cure™ UV 6041 should be avoided. Consult SDS for full safety information.

There is a Conrad shop in your region.  You can shop in your own language, have access to your local customer service and enjoy local transport for your purchase.

Optically Clear Adhesivefilm

Fast curing, water-white clear, urethane acrylate designed for utilization as an LCD interface adhesive. Sold in standard and HV (High Viscosity) versions. This product is a soft, flexible, low modulus polymer that provides a high amount of bond strength without imparting stress. This is a non-yellowing adhesive that exhibits excellent resistance to moisture.

It is recommended that you contact HumiSeal technical support to discuss your application and review the required recommended minimum cure requirements.

LOCA glue remover

Chase Global Operations Center and Corporate Headquarters 375 University Avenue Westwood, MA 02090 Tel. 781.332.0700 Fax 781.332.0701

“Note, adhesive thickness range of 700 – 750 microns was used during the development of the minimum required dosage values recommended below.  If a different adhesive thickness is used, process adjustments may be required.”

HumiSeal Vivid Cure™ UV6041 & HV (High Viscosity) adhesive has been formulated to allow flexibility in the curing process. HumiSeal Vivid Cure™ UV6041 can be cured using full-spectrum mercury vapor light systems as well as 365nm and 395nm LED systems. The table below details minimum dosage values required to properly crosslink HumiSeal Vivid Cure™ UV6041.

Due to the spectral output differences emitted between LED and mercury vapor systems, wavelength-specific minimum requirements will vary. 365nm is the preferred wavelength due to its efficiency in crosslinking the HumiSeal Vivid Cure™ UV6041.