Since 1990 Bill’s Hot Rod Co. has had one goal in mind; to design alternator, air conditioner and power steering brackets that fit and are easy to use, as well as affordable and stylish. The 1200 Series Power Steering Bracket will fit GM Saginaw Pumps with attached reservoirs. Brackets come completely assembled with all stainless steel bolts and washers, illustrated instruction sheet, and belt size recommendations with adjusting tips.  To be used in conjunction with 1100 Series Alternator bracket.

\begin{align} p\text{-polarized} & = \text{vertically polarized}\\ s\text{-polarized} & = \text{horizontally polarized} \end{align}

Circularly polarized light

s and p polarizations are different from horizontal and vertical polarizations. As described above, horizontal and vertical usually refer to the direction of the electric field with respect to gravity. s and p polarizations are instead defined with respect to a reference frame which is related to the surface with which the light is interacting. The surface can be oriented in an arbitrary direction with respect to gravity so we see that s and p are unrelated to horizontal and vertical polarization.

Electric polarization

Note regarding glare and sunglasses and the Brewster angle: You have pointed out that unpolarized light incidence at (or near) the brewster angle will be filtered and (mostly) s-polarized upon reflection. If the surface under consideration is horizontal (asphalt on the road, or standing water, for example) then we know that s-polarized light is h-polarized light. Thus if we want to filter this out using sunglasses for example we should make the sunglasses eliminate h-polarized light. Polarizing sunglasses are designed to eliminate h-polarized light when the wearer is standing upright and holding their head in the usual way. If they tilt their head, however, then their sunglasses will now let in more h-polarized light and allow in more v-polarized light. The angle of the sunglasses defines a new coordinate system. Note also that if the surface is vertically oriented (such as the rear window of the car in front of you) then since sunlight is typically coming from above, the s-polarized reflected light will again be mostly horizontally polarized. This means that generally polarizing sunglasses are good and reducing glare from all sorts of objects assuming the sunlight is coming from above. However, during sunrise and sunset the sun is lower in the sky so the reflected s-polarized light may now have large components in the vertical direction so the sunglasses will not work as effectively.

If that's the case then sunlight (unpolarized light) will be reflected as horizontally polarized so to reduce glare effects the polarizing sunglasses must block the horizontal direction of polarization, right?

Polarization

However, imagine a beam travelling directly upwards from the ground in the $\hat{z}$ direction. In this case the polarization lies in the $\hat{x}$, $\hat{y}$ plane. It doesn't make sense to me to call either of these vertical polarization. Rather, we would be better served calling them "East-West" and "North-South" polarized, for example. The key point here is the geometric and coordinate dependent nature of how we call polarizations.

My doubt comes from a discussion we had in class about the Brewster angle, glare effect produced by the reflection of sunlight on water and polarizing sunglasses.

H and V polarization usually refer to some arbitrary reference frame. This reference frame is usually defined by the direction of gravity (call this $\hat{z}$ direction). If light is travelling "horizontally" (meaning perpendicular to the direction of gravity, for example in the $\hat{y}$ direction) then we can talk about horizontally and vertically polarized light. For vertically polarized light the electric field is parallel to the direction of gravity so it is in the $\hat{z}$ direction. For horizontally polarized light the electric field is perpendicular to the direction of gravity, that is in the $\hat{x}$ direction. Note that in both cases the electric field is perpendicular to the direction of light propagation.

polarization中文

So an unpolarized electromagnetic wave as light when incident on an interface air-water will be reflected as an "s" polarized light at the Brewster angle. This means it oscillates on a plane perpendicular to the plane of incidence, hence parallel to the surface? If yes, then can we say that an s-polarized light is equivalently said to be horizontally polarized?

S-polarization

To protect and preserve the finish on these powdercoated or chrome plated brackets, be sure to apply a good qualitywaxsuch as carnauba, as needed.

p-polarized light is light where the electric field vector lies in this plane of incidence. s-polarized light is light where the electric field vector is perpendicular to this plane of incidence. If you think about this in terms of the material surface you can see that the electric field vector either pokes in or out of the material surface for p-polarized light while it "lies flat" in the plane of the material surface.

I put the tilde on the p to v comparison because for glancing angles (where the light is travelling almost horizontal, large angle of incidence) it makes sense to talk about vertical polarized light but if the light is travelling more and more perpendicular to the surface (smaller angles of incidence) it makes less and less sense to talk about vertically polarized light.

This definition of horizontal and vertical polarization also makes sense for light travelling at some reasonable angular deviations from the horizontal plane. We can talk about polarizations which mostly don't have components in the $\hat{z}$ direction, horizontal polarizations, and polarizations which mostly do have components in the $\hat{z}$, vertical polarizations.

Political polarization

*However for the case of light which is shining directly incident onto a material surface the two vectors are parallel and no plane is defined. I'll discuss this case shortly.

Stack Exchange network consists of 183 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

If the electric field is directly incident on the surface the propagation direction and surface normal are parallel so we cannot define a plane of incidence. In this case all polarizations "lie flat" in the plane of the material surface so it is sort of like all polarizations are "s-polarized". This is comparable to the case when light was travelling directly upwards against gravity and all polarizations looked like horizontal polarizations so it didn't make sense to talk about horizontal and vertically polarized light anymore. In this case we must introduce a new different reference frame if we want to talk about the polarization of the light field.

Bracket mounts to the lower left front of the block using the two lower bolt holes located by the timing chain cover (the old front motor mount holes).

Your personal data will be used to support your experience throughout this website, to manage access to your account, and for other purposes described in our privacy policy.

s and p are defined with respect to the plane of incidence as described in the Wikipedia article. The plane of incidence is defined by two vectors. One vector is the normal vector to the surface (the vector which points out of the surface). The other vector is the direction of propagation for the light under consideration. Often these two vectors are not parallel and thus they describe a plane*. This plane is called the plane of incidence.

Finally to unite all of these concepts. We see that horizontal and vertical polarization refer to the direction of polarization compared to the direction of gravity and s and p-polarization refer to the direction of polarization compared to the plane of incidence. If the surface normal is pointing either in the direction of gravity (as implied by the figure in the OP) or perpendicular to the direction of gravity (a surface which is vertical like a mirror in the restroom) then there is a relationship between s and p-polarized and horizontal and vertically (h and v) polarized light.