OPTODYNE UV is a clear, ultraviolet (UV) curable, optical adhesive based on fluorinated epoxy and fluorinated epoxy acrylate resins.

With so many 3.3V devices around now I decided to build a cheap and simple little 3.3V supply for breadboard prototypes. This supply is dead simple to make and only took about 25 minutes to build start to finish.

I always seem to need power supplies for things and didn't want to build a complete power supply and pay $25 just for the transformer again! So in order to save money we'll try repurpose an old cell phone charger from the junk box which is essentially free.

Mid-infrared (IR) waveplates have monolithic design. Mid-infrared (IR) waveplate has quarter- and half-wave retardation selection from 3500 nm to 10600 nm.

Jan 30, 2023 — What Is Single-Point Diamond Turning? Single-point diamond turning is a manufacturing process that's used to produce low to moderate volumes of ...

VERNIER Go Direct Konstantstromsystem Das Konstantstromsystem ist eine Gleichstromquelle, die einen. Vernier Software & Technology. 158,98 €*.

In the end I used an old Samsung charger because the wires were thicker and more robust (and there's no possibility that it will ever be used with a 10 year old cell phone again!)

Here I try out old Samsung and Apple chargers which both worked with an approximate 500 ma load. That's about the maximum that I'll be using on a breadboard but both devices are rated to 1 amp if you need it. If you need a lot of current you may need to heatsink the regulator. At low currents you can get by without a heatsink.

ND filters gevonden bij de Kamera Superstore voor Foto, Video, Objectieven, Lenzen, Accessoires en toebehoren, Studio en Licht, Verrekijkers, Telescopen, ...

Distrelec Norway stocks a wide range of Breadboards & Accessories. Next Day Delivery Available, Friendly Expert Advice & Over 180000 products in stock.

Yes. Just make sure to clean your glasses properly. It's easier to damage the AR in a noticeable manner compared to an uncoated lens. No tissues ...

Laser Paper · ThermoFlex® Color Up · Sublimation ... Flocking Sheets add a 3D Flock effect to HotMelt™ or screen print adhesive. ... Flocking Sheets. Cut Settings ...

20221219 — I am looking for a high quality magnifying glass, for hiking and for backyard exploration. I have seen a lot of options on places like Amazon.

The circuit is dead simple. Just connect the cell phone charger to the voltage regulator input and get 3.3V from the output. You should include the filter caps on the input and output, but you could get away with leaving them out. An indicator LED is optional too.

1 - scrap of vector board1 - LD33V (L1117) voltage regulator1 - Surplus 5V cell phone charger with up to 1A capacity1 - 0.1uF capacitor1 - 10uF capacitor1 - 220 ohm resistor1 - LED2 - Jumper wiresSolderAbout 25 minutes of time

There are 25.4 millimeters in one inch. Therefore to get amount of inches in millimeters, value in millimeters has to be divided by amount of millimeters in one inch:

If you are new to electronics, you may want to build the circuit on a breadboard first just so that you are confident about how to hook it up before committing to the permanent build.

Values of the relative refractive index for two grades of calcium fluoride in N2 gas corrected to a temperature of 20 degrees C and a pressure of one ...