\begin{align} \mathbf{E} &=\operatorname{Re}\left\{\widetilde{\mathbf{E}} e^{j \omega t}\right\} \nonumber \\ &=\operatorname{Re}\left\{(\hat{\mathbf{x}}+j \hat{\mathbf{y}}) E_{0} e^{-j \beta z} e^{j \omega t}\right\} \nonumber \\ &=\hat{\mathbf{x}}E_{0} \cos (\omega t-\beta z)+\hat{\mathbf{y}}E_{0} \cos \left(\omega t-\beta z+\frac{\pi}{2}\right) \end{align}

Polarization of electromagnetic waves pdf

A wave is said to exhibit circular polarization if the electric field vector rotates with constant magnitude. Left- and right-circular polarizations may be identified by the direction of rotation with respect to the direction of propagation.

Circular polarization

GCD-501100M employs integrated enclose design which improves the stability as well as the dustproof ability of the stage. Furthermore, GCD-501100M equipped with center reset function that allows the users to relocate the stage at the center of travel rapidly and conveniently, facilitates complex operations.

Linear polarization arises when the source of the wave is linearly polarized. A common example is the wave radiated by a straight wire antenna, such as a dipole or a monopole. Linear polarization may also be created by passing a plane wave through a polarizer; this is particularly common at optical frequencies (see “Additional Reading” at the end of this section).

\begin{align} \tilde{\mathbf{E}} &=\tilde{\mathbf{E}}_{x}+\tilde{\mathbf{E}}_{y} \nonumber \\ &=\left(\hat{\mathbf{x}} E_{x}+\hat{\mathbf{y}} E_{y}\right) e^{-j \beta z} \label{m0131_eCirc1} \end{align}

Polarizedand unpolarized light

What is polarization of waves in Physics

A wave is said to exhibit linear polarization if the direction of the electric field vector does not vary with either time or position.

When written in this form, \(\phi=0\) corresponds to \(\widetilde{\bf E}=\widetilde{\bf E}_x\), \(\phi=\pi/2\) corresponds to \(\widetilde{\bf E}=\widetilde{\bf E}_y\), and any other value of \(\phi\) corresponds to some other constant orientation of the electric field vector; see Figure \(\PageIndex{1}\) for an example.

What is linearlypolarized wave

This page titled 9.6: Wave Polarization is shared under a CC BY-SA 4.0 license and was authored, remixed, and/or curated by Steven W. Ellingson (Virginia Tech Libraries' Open Education Initiative) via source content that was edited to the style and standards of the LibreTexts platform.

Polarization refers to the orientation of the electric field vector. For waves, the term “polarization” refers specifically to the orientation of this vector with increasing distance along the direction of propagation, or, equivalently, the orientation of this vector with increasing time at a fixed point in space. The relevant concepts are readily demonstrated for uniform plane waves, as shown in this section. A review of Section 9.5 (“Uniform Plane Waves: Characteristics”) is recommended before reading further.

The rotation of the electric field vector can also be identified mathematically. When \(E_x = E_0\) and \(E_y = +jE_0\), Equation \ref{m0131_eCirc1} can be written:

To begin, consider the following uniform plane wave, described in terms of the phasor representation of its electric field intensity:

Note that \(\widetilde{\bf E}_y\) is identical to \(\widetilde{\bf E}_x\) except that the electric field vector now points in the \(+\hat{\bf y}\) direction and has magnitude and phase that is different by the factor \(E_y/E_x\). This wave too is said to exhibit linear polarization, because, again, the direction of the electric field is constant with both time and position. In fact, all linearly-polarized uniform plane waves propagating in the \(+\hat{\bf z}\) direction in lossless media can be described as follows: \[\widetilde{\bf E} = \hat{\bf \rho}E_{\rho} e^{-j\beta z} \nonumber \] This is so because \(\hat{\bf \rho}\) could be \(\hat{\bf x}\), \(\hat{\bf y}\), or any other direction that is perpendicular to \(\hat{\bf z}\). If one is determined to use Cartesian coordinates, the above expression may be rewritten using (Section 4.3)

\[\hat{\bf \rho} = \hat{\bf x}\cos\phi + \hat{\bf y}\cos\phi \nonumber \] yielding \[\widetilde{\bf E} = \left( \hat{\bf x}\cos\phi + \hat{\bf y}\cos\phi \right) E_{\rho} e^{-j\beta z} \label{m0131_eLinAI} \]

Linear polarization

Polarized wavemeaning

In engineering applications, circular polarization is useful when the relative orientations of transmit and receive equipment is variable and/or when the medium is able rotate the electric field vector. For example, radio communications involving satellites in non-geosynchronous orbits typically employ circular polarization. In particular, satellites of the U.S. Global Positioning System (GPS) transmit circular polarization because of the variable geometry of the space-to-earth radio link and the tendency of the Earth’s ionosphere to rotate the electric field vector through a mechanism known Faraday rotation (sometimes called the “Faraday effect”). If GPS were instead to transmit using a linear polarization, then a receiver would need to continuously adjust the orientation of its antenna in order to optimally receive the signal. Circularly-polarized radio waves can be generated (or received) using pairs of perpendicularly-oriented dipoles that are fed the same signal but with a \(90^{\circ}\) phase shift, or alternatively by using an antenna that is intrinsically circularly-polarized, such as a helical antenna (see “Additional Reading” at the end of this section).

Linear and circular polarization are certainly not the only possibilities. Elliptical polarization results when \(E_x\) and \(E_y\) do not have equal magnitude. Elliptical polarization is typically not an intended condition, but rather is most commonly observed as a degradation in a system that is nominally linearly- or circularly-polarized. For example, most antennas that are said to be “circularly polarized” instead produce circular polarization only in one direction and various degrees of elliptical polarization in all other directions.

Polarisedwavedefinition a level

The LibreTexts libraries are Powered by NICE CXone Expert and are supported by the Department of Education Open Textbook Pilot Project, the UC Davis Office of the Provost, the UC Davis Library, the California State University Affordable Learning Solutions Program, and Merlot. We also acknowledge previous National Science Foundation support under grant numbers 1246120, 1525057, and 1413739. Legal. Accessibility Statement For more information contact us at info@libretexts.org.

A commonly-encountered alternative to linear polarization is circular polarization. For an explanation, let us return to the linearly-polarized plane waves \(\widetilde{\bf E}_x\) and \(\widetilde{\bf E}_y\) defined earlier. If both of these waves exist simultaneously, then the total electric field intensity is simply the sum:

GCD-501100M High precision motorized linear stage is newly developed by Daheng. GCD-501100M consists of high precision ball screw and fine linear guide. The combination of GCD-501100M with GCD-0401(Motorized stage controller) is able to provide super high accurate linear motions (error in microns). The features of high precision and high stability are highly demanded by the applications of THz spectrometer and fs/ ps Lasers micromachining systems.

In the example above, the electric field vector rotates either clockwise or counter-clockwise relative to the direction of propagation. The direction of this rotation can be identified by pointing the thumb of the left hand in the direction of propagation; in this case, the fingers of the left hand curl in the direction of rotation. For this reason, this particular form of circular polarization is known as left circular (or ”left-hand” circular) polarization (LCP). If we instead had chosen \(E_y = -jE_0 = -jE_x\), then the direction of \({\bf E}\) rotates in the opposite direction, giving rise to right circular (or “right-hand” circular) polarization (RCP). These two conditions are illustrated in Figure \(\PageIndex{3}\).

As anticipated, we see that both \({\bf E}_x\) and \({\bf E}_y\) vary sinusoidally, but are \(\pi/2\) radians out of phase resulting in rotation in the plane perpendicular to the direction of propagation.

Here \(E_x\) is a complex-valued constant representing the magnitude and phase of the wave, and \(\beta\) is the positive real-valued propagation constant. Therefore, this wave is propagating in the \(+\hat{\bf z}\) direction in lossless media. This wave is said to exhibit linear polarization (and “linearly polarized”) because the electric field always points in the same direction, namely \(+\hat{\bf x}\). Now consider the wave

If the phase of \(E_x\) and \(E_y\) is the same, then \(E_x = E_{\rho}\cos\phi\), \(E_y = E_{\rho}\sin\phi\), and the above expression is essentially the same as Equation \ref{m0131_eLinAI}. In this case, \(\widetilde{\bf E}\) is linearly polarized. But what if the phases of \(E_x\) and \(E_y\) are different? In particular, let’s consider the following case. Let \(E_x = E_0\), some complex-valued constant, and let \(E_y = +jE_0\), which is \(E_0\) phase-shifted by \(+\pi/2\) radians. With no further math, it is apparent that \(\widetilde{\bf E}_x\) and \(\widetilde{\bf E}_y\) are different only in that one is phase-shifted by \(\pi/2\) radians relative to the other. For the physical (real-valued) fields, this means that \({\bf E}_x\) has maximum magnitude when \({\bf E}_y\) is zero and vice versa. As a result, the direction of \({\bf E}={\bf E}_x+{\bf E}_y\) will rotate in the \(x-y\) plane, as shown in Figure \(\PageIndex{2}\).