Backside illuminated

D. Bae, T. Pedersen, B. Seger, M. Malizia, A. Kuznetsov, O. Hansen, I. Chorkendorff and P. C. K. Vesborg, Energy Environ. Sci., 2015, 8, 650 DOI: 10.1039/C4EE03723E

bsi cmos是什么

Si is an excellent absorber material for use in 2-photon photoelectrochemical hydrogen production. So far nearly all studies of silicon photoelectrodes have employed frontal illumination despite the fact that in most water-splitting 2-photon device concepts the silicon is the “bottom” cell in the tandem stack and therefore illuminated from the back with respect to the electrolyte. In the present work, we investigate back-illuminated Si photoelectrodes experimentally, as well as by modelling, the dependence of induced photocurrent on various parameters, such as carrier diffusion length (Le) and surface recombination velocity (vs) to quantify their relative importance. A bifacial light absorbing structure (p+pn+ Si) is tested under back-illumination conditions which mimic the actual working environment in a tandem water splitting device. The thickness of the absorbing Si layer is varied from 30 to 350 μm to assess the impact of the diffusion length/thickness ratio (Le/L) on photocatalytic performance. It is shown how the induced photocurrent (JL) of a back-illuminated sample increases as wafer thickness decreases. Compared to the 350 μm thick sample, a thinned 50 μm thick sample shows a 2.7-fold increase in JL, and consequently also a higher open circuit voltage. An analytical model is developed to quantify how the relative Le/L-ratio affects the maximum JL under back-illumination, and the result agrees well with experimental results. JL increases with the Le/L-ratio only up to a certain point, beyond which the surface recombination velocity becomes the dominant loss mechanism. This implies that further efforts should to be focused on reduction of surface recombination. The present study is the first experimental demonstration of a Si wafer based photocathode under back-illumination. Moreover, the comparative experimental and theoretical treatment also highlights which photoabsorber properties merit the most attention in the further development towards full tandem water splitting devices.

c Centre for Materials Science and Nanotechnology, Department of Physics, University of Oslo, 0316 Oslo, Norway

Exmor

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

Sorry, we just need to make sure you're not a robot. For best results, please make sure your browser is accepting cookies.

Optical format

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

b Department of Micro- and Nanotechnology, Technical University of Denmark, 2800 Kgs. Lyngby, Denmark

a Center for Individual Nanoparticle Functionality, Department of Physics, Technical University of Denmark, 2800 Kgs. Lyngby, Denmark E-mail: Peter.Vesborg@fysik.dtu.dk Fax: +45 4593 2399 Tel: +45 4525 3276

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.