** The maximum working pressure (MWP) of a hose assembly is limited to the lowest of the MWP’s of either of the two end fittings, or of the hose itself as listed above. The MWP of the hose reduces as the operating temperature increases, consult Aflex Hose for guidance.

1” PTFE lined PN10 flange spigots on heated hoses can only have a maximum flare diameter of 50mm, not 63mm. If the hose is “hanging”, straight or at 90˚, under its own weight, special construction is required, so advise Aflex Hose accordingly. Minimum ETH Hose assembly length, when collars are used 1mtr.

Chemically inert and easy to clean, Bioflex Ultra is a corrosion resistant hose for the pharmaceutical, food and beverage and chemical industries. This flexible hose provides reliability, performance and long service life.

The heating element comprises self-regulating element spirally wrapped around the hose assembly. Self-regulating elements may require a sensor and controller if a specific maintain temperature is required. Please consult Aflex Hose for clarification. The power leads and (if applicable) temperature sensor leads emerge from the hose assembly at one end, through glands and conduits. The thermal insulation is foam rubber, silicone foam rubber. The outer cover may be a polypropylene braid or SS wire braid with a blue or black EPDM rubber cover.

Each hose is custom designed and built. Application details must be supplied by filling in an “ETH Hose Questionnaire”, available from the website. Generally, for hazardous areas, particularly “Zone 1”, the Self-Regulating type of heating element is employed, with or without a temperature sensor and control, and flameproof glands and conduit are also required. The watts per metre of the heating element, the pitch of the spiral on the hose, and the thickness of the thermal insulation are all calculated in accordance with established formulae to give the required maintained temperature.

PTFE-lined hose for biotechnology and pharmaceutical fluid transfers Chemically inert and easy to clean, Bioflex Ultra is a corrosion resistant hose for the pharmaceutical, food and beverage and chemical industries. This flexible hose provides reliability, performance and long service life.

As for Bioflex Ultra GP, SS in Specifications, except that the minimum bend radius is tripled and the outside diameter and weight are significantly increased in line with the particular design. The maximum length of a CH/ETH hose is 10m (33ft).

*The 7⁄8", 13⁄8" and 17⁄8" hose sizes are only suitable for use with PTFE lined sanitary clamp (or triclover) end fittings and PTFE lined I-Line end fittings.

For use in applications where the temperature of the process fluid must be regulated as it passes through the hose. In some applications, an additional ‘melt out’ facility may also be required.

Technical Summary table lists features available within the range. See ‘Specifications’ tab for model specific information.